TESmart control

Inputs Active: —

LCD message Appears on the floating kit and here · keeps the last 10

Peek

Auto cycle

Switch settings

Buzzer

Front-panel display timeout

Auto input detection

The switch cannot report these values. Highlighted is the last value this host sent — remembered in the listener env file across restarts.

Input names

Saved as you type. Stored on this computer, not in the switch.

Cycle

Saved as you change it. Automatic runs while this page is open with Auto cycle on.

Network

IP address: —
Port: —
Gateway: —
Mask: —

A wrong value here makes the switch unreachable over the network. There is no factory reset; recovery needs an RS232 cable. You will be asked to confirm twice.

Stored immediately; takes effect after a power cycle. A wrong address is only recoverable over RS232.

Mesh off

Mesh is off on this listener.

Switch: —
Proxy: —
Mesh mDNS: —
Started: —

Peers

With --mesh, the oldest listener for this TCP switch owns the connection. Others relay through it.

Backup

Export this listener’s configuration (names, enablement, cycle, peek, messages, callbacks, listen settings, and kit prefs) so you can import it on another computer.

Import replaces the env file on this listener. Adjust the switch address afterward if the new host uses a different IP.